Commit 763914ef authored by Sungbo Eo's avatar Sungbo Eo Committed by Adrian Schmutzler

ramips: improve netis WF-2881 support

This patch does the following:

1. remove u-boot-env partition
   Stock bootloader saves env variables at 0x80000 in flash,
   and there is nothing stored at 0x30000.
   By merging the partition "u-boot-env" with "u-boot",
   the partition table becomes the same as used in stock firmware:
   00000000-00080000: "Bootloader"
   00080000-00100000: "Config"
   00100000-00140000: "Factory"
   00140000-07f80000: "Kernel"

2. fix LAN/WAN MAC addresses and provide label MAC address
   Ethernet MAC addresses are stored in factory partition at:
   0xe000: LAN (label_mac)
   0xe006: WAN (label_mac+1)

3. fix LAN port order
   WF-2881 LAN ports are in reverse order of switch ports.

4. fix WiFi LEDs
   mt76 led nodes are added to make WiFi LEDs work.
   On top of this, mt76 node names are changed to more generic ones,
   and compatible strings are also added.

5. fix pinmux groups
   uart3 and uart2 pins are used as button and led, but jtag pins are not.
Signed-off-by: default avatarSungbo Eo <mans0n@gorani.run>
parent 2c541355
......@@ -14,6 +14,7 @@
led-failsafe = &led_wps;
led-running = &led_wps;
led-upgrade = &led_wps;
label-mac-device = &ethernet;
};
chosen {
......@@ -57,13 +58,7 @@
partition@0 {
label = "u-boot";
reg = <0x0 0x30000>;
read-only;
};
partition@30000 {
label = "u-boot-env";
reg = <0x30000 0x1000>;
reg = <0x0 0x80000>;
read-only;
};
......@@ -82,7 +77,7 @@
partition@140000 {
compatible = "denx,uimage";
label = "firmware";
reg = <0x140000 0x7E40000>;
reg = <0x140000 0x7e40000>;
};
};
};
......@@ -92,29 +87,41 @@
};
&pcie0 {
mt76@0,0 {
wifi@0,0 {
compatible = "mediatek,mt76";
reg = <0x0000 0 0 0 0>;
mediatek,mtd-eeprom = <&factory 0x8000>;
ieee80211-freq-limit = <5000000 6000000>;
led {
led-sources = <2>;
led-active-low;
};
};
};
&pcie1 {
mt76@0,0 {
wifi@0,0 {
compatible = "mediatek,mt76";
reg = <0x0000 0 0 0 0>;
mediatek,mtd-eeprom = <&factory 0x0000>;
ieee80211-freq-limit = <2400000 2500000>;
led {
led-sources = <2>;
led-active-low;
};
};
};
&ethernet {
mtd-mac-address = <&factory 0xe006>;
mtd-mac-address = <&factory 0xe000>;
};
&pinctrl {
state_default: pinctrl0 {
gpio {
ralink,group = "uart3", "jtag";
ralink,group = "uart3", "uart2";
ralink,function = "gpio";
};
};
......
......@@ -18,7 +18,6 @@ ramips_setup_interfaces()
mediatek,mt7621-eval-board|\
mqmaker,witi|\
mtc,wr1201|\
netis,wf-2881|\
phicomm,k2p|\
planex,vr500|\
samknows,whitebox-v8|\
......@@ -113,7 +112,8 @@ ramips_setup_interfaces()
netgear,r6260|\
netgear,r6350|\
netgear,r6850|\
netgear,wndr3700-v5)
netgear,wndr3700-v5|\
netis,wf-2881)
ucidef_add_switch "switch0" \
"0:lan:4" "1:lan:3" "2:lan:2" "3:lan:1" "4:wan" "6@eth0"
;;
......@@ -150,6 +150,7 @@ ramips_setup_macs()
elecom,wrc-1900gst|\
elecom,wrc-2533gst|\
lenovo,newifi-d1|\
netis,wf-2881|\
phicomm,k2p|\
planex,vr500|\
samknows,whitebox-v8|\
......
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment